[eside-ghost] pendrive mp3 msj de error...

[María Unda]

ups... los mensajes, que antes se me ha ido, sorryp

Esto es lo que me pone al enchufar el jetflash...


andromeda:~# usb 1-1: new full speed USB device using address 8
usb 1-1: Product: TS1GJF2A
usb 1-1: Manufacturer: JetFlash
scsi6 : SCSI emulation for USB Mass Storage devices
   Vendor: JetFlash  Model: TS1GJF2A          Rev: 1.00
   Type:   Direct-Access                      ANSI SCSI revision: 02
SCSI device sda: 2007000 512-byte hdwr sectors (1028 MB)
sda: assuming Write Enabled
sda: assuming drive cache: write through
  sda:<7>usb-storage: queuecommand called
  sda1
Attached scsi removable disk sda at scsi6, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi6, channel 0, id 0, lun 0,  type 0


Y al montarlo, sin problemas.

Y al enchufar el otro también lo reconoce pero no sé si no pilla bien el 
formateo o que...


andromeda:~# usb 1-1: new full speed USB device using address 7
scsi5 : SCSI emulation for USB Mass Storage devices
Vendor: iRiver    Model: iFP Mass Driver   Rev: 1.00
Type:   Direct-Access                      ANSI SCSI revision: 02
SCSI device sda: 512000 512-byte hdwr sectors (262 MB)
sda: assuming Write Enabled
sda: assuming drive cache: write through
Buffer I/O error on device sda, logical block 0
unable to read partition table
Attached scsi removable disk sda at scsi5, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi5, channel 0, id 0, lun 0,  type 0

Y al montarlo, na, claro:

andromeda:/home/pitu# mount -t vfat /dev/sda1 /mnt
mount: /dev/sda1 is not a valid block device



vnga, gracias!